| Weight Rating Closed |
80,000 lbs., evenly distributed. |
| Weight Rating Extended |
80,000 lbs., evenly distributed over the kingpin and running gear. Note: The running gear should be in the forward position when trailer is fully extended. |
| GVWR |
65,000 lbs. |
| Tare Weight |
16,300 lbs. (+/- 3%) |
| Length |
48 feet, extendable to 80 feet. (11ft. front section; 37 ft. rear section). |
| Width |
96" |
| Tandem Center Line |
24" |
| Maximum Rear Height |
Approximately 59" |
| Main Beams - Top/Bottom Flange |
½" x 6" Grade 80 |
| Main Beams - Forward Web Section |
¼" thick Grade 50. |
| Main Beams - Rear Web Section |
7 gauge Grade 50. |
| Cross Member |
4" x 3.19 lbs/ft. structural I-Beam on 12" centers. (102" available.) |
| Side Rail |
513/16" roll-formed steel channel. (8" channel available.) |
| Rub Rail |
¼" x 2 ½" flat steel with single pipe spool spacers between stake pockets. (Double spools available) |
| Stake Pockets |
15/8" deep, 3½" wide, 4" tall (inside dimensions). |
| Stake Pockets - Rear |
Three exterior |
| Stake Pockets - Side |
On 24" centers |
| Stabilizers |
Seven outriggers per side |
| Upper Coupler |
Pick up plate is 5/16" thick and is reinforced fore and aft of the kingpin by ¼" formed channels. (3/8" available.) |
| ICC Bumper |
4" square tube step bumper, D.O.T. approved underride guard, one set of two-hole rubber dock bumpers. |
| Floor |
11/8" thick Apitong or Angelin Pedra, two screws per board. |
| Rollers |
Steel upper and lower rollers insure a smooth sliding extension and closure. |
| Locking Pins |
Air-actuated locking pins. |
| Landing Gear |
Jost two-speed. AAR approved, square leg. 50,000 lb. lift capacity and 140,000 lb. static load capacity. 126" from front of trailer. 10" x 10" low-profile sandshoe. Roadside
handle. |
| Suspension |
Binkley, spring-ride, three leaves. (Air available.) |
| Axles |
Meritor Type TN, on 49" centers. Wall thickness ½", axle
track 71.5. |
| Hubs |
Steel hub piloted disc wheels. |
| Wheels |
White steel rims, outboard mounted drums. 8¼ x 22.5 hub,
piloted, tubeless. 11R 22.5 tires. |
| Brakes |
WABCO Brake System Type 2S1M, Haldex brake chambers, Bendix 5½" slack adjusters. |
| Electrical System |
12 volt, 7-way split pin receptacle plug; modular wiring harness. Air and electrical are embedded in Gotrac’s Nylatrac cable and hose carrier which eliminates having to disconnect and reconnect the air and electric. |
| Lights |
TruckLite grommet mounted incandescent. (LED available.) |
| Finish |
70% Zinc rich primer over clean, dry steel and NACE No. 3/SSPC-SP-6 Commercial blast cleaning. Black urethane topcoat. |
| Markings |
FHWA plate, tare weight. Conspicuity meets DOT requirements. Plastic registration holder. |
| Mud Flaps |
Evans mudflaps, four mounting bolts. |
| Steel & Fasteners |
All structural steel is ASTM-A572, Grade 50, or ASTM-A607, Grade 50. All structural fasteners are Grade 5 or better and are zinc coated. |